I would like to set up our own network in our building-ġ / would put an Airport Extreme there is the ethernet cable and then plug the cable into the WAN portĢ / I would implement the EA to distribute IP addresses, but using a different pool - so if the main building uses 192.168.1.1 to 192.168.1.256, I would be created my AE to use 10.1.1.1 to 10.1.1.256ģ / I would then run an ethernet cable between the port LAN on EI to my Netgear 24 port switch.Ĥ / I would connect all our other airport extreme and express again our Ethernet switch and put them all to 'bridge mode '. The ethernet line give you IP addresses and internet link. I rent an office and we have an ethernet cable coming into our building to the main network (a fiber broadband building next door). Set up a branch to the main ethernet using Airport Extreme networkĬould someone help me with this network configuration please? If none of these things help, then you should ask Apple to replace the AirPort Extreme to you and hope for more luck in the next test. One of them would be to insert a Gigabit Ethernet switch between modem and AirPort Extreme to see if it will negotiate better speeds like thatĪnother would be to try an Ethernet cable between the modem and AirPort Extreme cross. Unfortunately, Apple has removed all the settings to manually adjust WAN port on the AirPort Extreme 802.11ac speed, so there is not much you can do others try a few unusual things. If you don't see results, then the AirPort Extreme is not to negotiate properly with your modem speeds. If the AirPort Extreme is configured in Bridge Mode, then you would expect to see 600 - 700 MB/s speed this way. If the AirPort Extreme 802.11ac is configured as a DHCP and NAT router, then the WAN to LAN speed will be limited to about 300-400 Mbps.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |